Installation [11/2021 - 03/2024]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark	*b	30° or less
   *c	Lower End of Rear Coil Spring	-	-
   	Inner Side of the Vehicle	-	-

   1. Set the rear coil spring to the rear No. 2 suspension arm assembly.
      NOTE:

      • Set the rear coil spring so that its lower end is within the range shown in the illustration.
      • Set the rear coil spring so that the identification mark is positioned as shown in the illustration.
      • The smaller diameter end must face upward.
   2. Using a jack and wooden block, slowly jack up the rear No. 2 suspension arm assembly and then install the rear No. 2 suspension arm assembly to the rear axle carrier sub-assembly with the bolt and nut.
      WARNING:

      Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

      NOTE:

      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
      • Make sure to perform this operation with the vehicle kept as low as possible.
      • Insert the bolt with the threaded end facing the front of the vehicle.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

      Torque: 73 N.m (744 kgf/cm, 54 ft.lbf) 

      NOTE:

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

Refer to INSTALLATION [11/2021 - ]

See step  10

Refer to INSTALLATION [11/2021 - 03/2023] , or refer to INSTALLATION [03/2023 - 03/2024]

Refer to ADJUSTMENT [11/2021 - ]