Removal [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- PRECAUTION NOTE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Refer to PRECAUTION [11/2021 - ]
- REMOVE SERVICE PLUG GRIP
See step 5
- REMOVE NO. 2 INVERTER PROTECTOR
Refer to PROCEDURE - Step 8
- DISCONNECT ENGINE ROOM MAIN WIRE
See step 4 - REMOVE CONNECTOR COVER ASSEMBLY
Refer to PROCEDURE - Step 10 - CHECK TERMINAL VOLTAGE
Refer to PROCEDURE - Step 11 - INSTALL CONNECTOR COVER ASSEMBLY
Refer to PROCEDURE - Step 8 - CONNECT ENGINE ROOM MAIN WIRE
See step 31 - INSTALL NO. 2 INVERTER PROTECTOR
Refer to PROCEDURE - Step 18
- REMOVE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 8 - REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 9
- REMOVE REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 21
- REMOVE NO. 3 BATTERY SERVICE COVER BOARD
Refer to PROCEDURE - Step 23
- REMOVE REAR DOOR SCUFF PLATE RH
- Use the same procedure as for the LH side.
- REMOVE NO. 2 BATTERY SERVICE COVER BOARD
- Use the same procedure as for the No. 3 battery service cover board.
- REMOVE BATTERY SERVICE COVER BOARD
See step 7
- REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
See step 8
- REMOVE NO. 1 HV BATTERY COVER PANEL RH
Refer to PROCEDURE - Step 12 - REMOVE ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY WARNING:
Be sure to wear insulated gloves and protective goggles.
NOTE:Insulate the disconnected high-voltage connector with insulating tape.