Removal [03/2024 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 7
REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 8
REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 9
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 10

REMOVE CRANKSHAFT POSITION SENSOR

Disconnect the crankshaft position sensor connector.
Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
NOTE:
If the crankshaft position sensor has been struck or dropped, replace it.
Perform this procedure only when reusing the crankshaft position sensor.
1. Remove the O-ring from the crankshaft position sensor.
NOTE:
- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
- If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.