LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> LX 600 Base >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pan And Oil Level Sensor >> Removal [12/2021 - ] >> Procedure

Removal [12/2021 - ]: Procedure

  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY 
    1. GTY1079693Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt A Bolt B
      Remove in this Direction - -
      1. Remove the 5 bolts (A) and 4 bolts (B).
      2. Move the side of the No. 1 engine under cover assembly facing the front of the vehicle toward the LH side and detach the temporary holding guide.
      3. Remove the No. 1 engine under cover assembly facing the front of the vehicle while pulling the engine side cover sub-assembly RH and engine side cover sub-assembly LH, and then remove the No. 1 engine under cover assembly while detaching the 2 temporary holding guides facing the rear of the vehicle as shown in the illustration.
  2. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 9

  3. DRAIN ENGINE OIL 

    Refer to PROCEDURE - Step 4

  4. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 73 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 73 [10/2023 - ]
  5. REMOVE ENGINE OIL LEVEL SENSOR 
    WARNING:

    To prevent burns, do not remove the engine oil level sensor while the engine is hot.
    1. GTY1074230Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the engine oil level sensor connector.
      2. Remove the clip from the engine oil level sensor.
      3. Using an 8 mm socket wrench, remove the 2 bolts and engine oil level sensor.
scientia non olet · About LEMON Manuals