Removal [12/2023 - ]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
Refer to PRECAUTION [12/2023 - ]
NOTE:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to REMOVAL [12/2023 - ]
- REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat)
Refer to REMOVAL [12/2023 - ]
- REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat, w/ Tonneau Cover)
Refer to PROCEDURE - Step 3
- REMOVE ROPE HOOK ASSEMBLY (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 10
- REMOVE REAR DECK TRIM COVER (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 11 - REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 12
- REMOVE REAR FLOOR BOARD REAR LH (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 13
- REMOVE REAR FLOOR BOARD REAR RH (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 14
- REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 15
- REMOVE FRONT DECK FLOOR BOX (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 16
- REMOVE REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 27
- REMOVE OUTER LAP BELT ANCHOR COVER
- REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (LAP BELT ANCHOR)
- REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (LAP BELT ANCHOR) (w/ Rear No. 2 Seat)
- REMOVE NO. 1 TONNEAU COVER HOLDER CAP
Refer to PROCEDURE - Step 47
- REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Refer to PROCEDURE - Step 48
- REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
HINT:
Remove the rear side of the rear door opening trim weatherstrip LH so that the deck trim side panel assembly LH and front quarter trim panel assembly LH can be removed.Refer to PROCEDURE - Step 2
- REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Refer to PROCEDURE - Step 49
- REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
Refer to PROCEDURE - Step 50
- REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
Refer to PROCEDURE - Step 51
- REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
- Loosen the bolt and remove the shoulder anchor of the rear No. 1 seat outer belt assembly LH.
- Disconnect the pretensioner connector.
HINT:
Refer to How to Connect or Disconnect Airbag Connector:
Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [12/2023 - ]
- Remove the 2 bolts.
- Detach the guide and remove the rear No. 1 seat outer belt assembly LH.