Installation [08/2021 - ]: Procedure

1. Engage the 3 hooks.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Push in the instrument panel passenger airbag assembly to engage the 3 hooks.
3. Install the instrument panel passenger airbag assembly with the 2 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 1

1. Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off.
2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
   WARNING:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Connect the 2 airbag connectors of the instrument panel wire to the instrument panel passenger airbag assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Airbag Connector
   *b	Airbag Connector Locking Button
   	Push in this Direction

   NOTE:

   • When connecting any airbag connector, take care not to damage the airbag wire harness.
   • Be sure to only connect the connectors to each corresponding color.
4. Push in the 2 airbag connector locking buttons as shown in the illustration to install the 2 airbag connectors to the instrument panel passenger airbag assembly.
5. Engage the clamp.

Refer to PROCEDURE - Step 3