LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> RX 350h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Starting System - Service Information) >> Starter >> Installation [10/2022 - ] >> Procedure

Installation [10/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 

    Bolt 

    Torque: 46 N.m (469 kgf/cm, 34 ft.lbf) 

    Nut 

    Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

  2. INSTALL FLYWHEEL HOUSING SIDE COVER 
    1. GTY1075052Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.
        NOTE:
        • Make sure the claw makes a click sound, indicating that it fits tightly.
        • Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
  3. CONNECT ENGINE WIRE 
  4. INSTALL INTAKE MANIFOLD WITH INTERCOOLER ASSEMBLY 

    Refer to INSTALLATION [10/2022 - ]

  5. INSTALL AIR CLEANER HOSE ASSEMBLY 
    Refer to PROCEDURE - Step 51
  6. CONNECT NO. 2 VENTILATION HOSE 
    Refer to PROCEDURE - Step 52
  7. INSTALL AIR CLEANER ASSEMBLY 
    Refer to PROCEDURE - Step 4
  8. INSTALL INLET AIR CLEANER ASSEMBLY 
  9. INSTALL COOL AIR INTAKE DUCT SEAL 
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 5

  11. ADD COOLANT (for Intercooler) 

    Refer to PROCEDURE - Step 5

  12. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 5

  13. INSPECT FOR COOLANT LEAK (for Intercooler) 

    Refer to PROCEDURE - Step 1

  14. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 1

  15. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 84

  16. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 85

  17. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 
  18. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH 
  19. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL 

    Refer to WORK PROCEDURE [10/2022 - ]

    HINT: 

    When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [10/2022 - 08/2023] , or refer to AUTOMATIC LEARNING CHART [08/2023 - ]

scientia non olet · About LEMON Manuals