LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> NX 350 Base >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    GTY1005576Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Refer to PRECAUTION [11/2021 - ]

    NOTE:

    After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [11/2021 - ]
  2. REMOVE BATTERY SERVICE COVER PLATE (for HEV Model) 

    Refer to PROCEDURE - Step 3

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:
    • Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
    • If an airbag deploys for any reason, it may cause a serious injury.
    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    for A25A-FKS:

    Refer to PROCEDURE - Step 2

    for T24A-FTS:

    Refer to PROCEDURE - Step 2

    for A25A-FXS:

    Refer to PROCEDURE - Step 3

  4. REMOVE DOOR SCUFF PLATE ASSEMBLY 

    Refer to PROCEDURE - Step 13

  5. REMOVE REAR SEAT CUSHION ASSEMBLY (for Gasoline Model) 
    for Manual Seat: 
    1. Refer to PROCEDURE - Step 8

    for Power Seat: 

    1. Refer to PROCEDURE - Step 11
  6. REMOVE REAR SEAT CUSHION LOCK HOOK (for Gasoline Model) 

    Refer to PROCEDURE - Step 9

  7. REMOVE REAR DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 21

  8. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP 
    1. GTY1054827Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. GTY1054824Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. GTY1055983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY 
    1. GTY1054823Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE CENTER PILLAR LOWER GARNISH 

    Refer to PROCEDURE - Step 30

  13. REMOVE CENTER PILLER GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 32

  14. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. GTY1253863Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the connector.
    2. GTY1073807Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
      2. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

        HINT: 

        Tape the screwdriver tip before use.

      3. Remove the bolt.
      4. Disengage the 2 guides to remove the front seat outer belt assembly.
    3. for Front Passenger Seat Belt with Selectable Force Limiter:
      GTY1056283Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the selectable force limiter connector.

        HINT: 

        Tape the screwdriver tip before use.

  15. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 

    HINT: 

    Perform this procedure only when replacement of the front shoulder belt anchor adjuster assembly is necessary.

    1. GTY1054801Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals