Installation [06/2018 - 08/2020]: Procedure

INSTALL NAVIGATION ECU
INSTALL NO. 1 RADIO RECEIVER BRACKET
1. Install the No. 1 radio receiver bracket with the 2 screws.

INSTALL NAVIGATION ECU WITH BRACKET

Engage the 4 claws to temporarily install the navigation ECU with bracket as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

Install the 2 screws.

Install the navigation ECU with bracket with the 2 screws.

INSTALL NO. 1 NAVIGATION WIRE
1. Connect the 2 connectors to install the No. 1 navigation wire.
INSTALL RADIO RECEIVER ASSEMBLY WITH SWITCH
Refer to PROCEDURE - Step 7
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 28
INSTALL LOWER INSTRUMENT PANEL LH
Refer to PROCEDURE - Step 29
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 31
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 32
INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 31
INSTALL COWL SIDE TRIM BOARD RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 32
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 33
INSTALL LOWER INSTRUMENT PANEL
Refer to PROCEDURE - Step 37
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 4
INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
for UA80E: Refer to PROCEDURE - Step 1

for P710: Refer to PROCEDURE - Step 1
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 8
INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 9