Installation [06/2018 - 10/2019]: Procedure

INSTALL DCM (TELEMATICS TRANSCEIVER)
1. Connect each connector.
2. Install the DCM (telematics transceiver) with the 2 nuts.
  
  Fig 1: DCM (Telematics Transceiver) Tightening Sequence [06/2018 - 10/2019]
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  HINT:
  
  Install the nuts in the order shown in the illustration.
INSTALL RADIO RECEIVER ASSEMBLY WITH SWITCH
Refer to PROCEDURE - Step 7
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 28
INSTALL LOWER INSTRUMENT PANEL LH
Refer to PROCEDURE - Step 29
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 31
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 32
INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 31
INSTALL COWL SIDE TRIM BOARD RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 32
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 33
INSTALL LOWER INSTRUMENT PANEL
Refer to PROCEDURE - Step 37
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 4
INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
for UA80E: Refer to PROCEDURE - Step 1

for P710: Refer to PROCEDURE - Step 1
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 8
INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 9
PERFORM DCM ACTIVATION
HINT:

After replacing the DCM (telematics transceiver), make sure to perform DCM activation.

for HV Model: Refer to DCM ACTIVATION [06/2018 - 10/2019]

for Gasoline Model: Refer to DCM ACTIVATION [06/2018 - 10/2019]
PERFORM REGISTRATION
*: for Lexus Enform Remote Compatible Type

HINT:

After replacing the DCM (telematics transceiver), make sure to perform code registration (Smart access system with push-button start (for Start Function)).

for HV Model: Refer to REGISTRATION [06/2018 - 10/2019]

for Gasoline Model: Refer to REGISTRATION [06/2018 - 10/2019]