LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Transfer Case - Service Information) >> TRANSFER CASE FRONT OIL SEAL (for RH Side) >> Replacement [08/2019 - ] >> Procedure

Replacement [08/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 7

  2. REMOVE NO. 3 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 8

  3. REMOVE FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 15

  4. DRAIN AUTOMATIC TRANSAXLE FLUID 

    Refer to PROCEDURE - Step 4

  5. DRAIN TRANSFER OIL 

    See step  1

  6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH 

    Refer to REMOVAL [08/2019 - ]

  7. REMOVE TRANSFER CASE OIL SEAL RH 
    1. Using SST, remove the transfer case oil seal RH from the transfer case sub-assembly.
      GTY633457Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transfer Case Oil Seal RH
      • SST: 09308-00010 
      NOTE:

      Do not damage the transfer case oil seal RH contact surface to the transfer case sub-assembly.

  8. INSTALL TRANSFER CASE OIL SEAL RH 
    1. Using SST and a hammer, install a new transfer case oil seal RH to the transfer case sub-assembly as shown in the illustration.
      GTY957537Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A Type A
      *B Type B
      *1 Transfer Case Oil Seal RH
      *a Depth
      Install in this Direction
      • SST: 09950-60010 
        1. 09951-00350
        2. 09951-00580
        3. 09952-06010
      • SST: 09950-70010 
        1. 09951-07150

      Standard Depth

      33.5 to 34.5 mm (1.32 to 1.36 in.)

      NOTE:
      • Be sure to install the transfer case oil seal RH in the correct orientation.
      • Tap in the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
      • Do not tap in the transfer case oil seal RH in too far.
    2. Apply a small amount of MP grease to the lip of the transfer case oil seal RH.
  9. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH 

    Refer to INSTALLATION [09/2015 - ]

  10. ADD TRANSFER OIL 

    See step  2

  11. ADD AUTOMATIC TRANSAXLE FLUID 

    Refer to ADJUSTMENT [08/2019 - ]

  12. INSPECT FOR OIL LEAK 
  13. INSTALL FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 64

  14. INSTALL NO. 3 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 71

  15. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 72

scientia non olet · About LEMON Manuals