LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Seat Belt - Service Information (Coupe)) >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  2. REMOVE FRONT SEAT ASSEMBLY LH 

    Refer to REMOVAL [05/2023 - ]

  3. REMOVE REAR SEAT CUSHION ASSEMBLY 

    Refer to PROCEDURE - Step 1

  4. REMOVE REAR SEAT CUSHION LOCK HOOK 

    Refer to PROCEDURE - Step 2

  5. REMOVE REAR SEAT SIDE GARNISH 

    Refer to PROCEDURE - Step 3

  6. REMOVE REAR SEATBACK COVER 

    Refer to PROCEDURE - Step 5

  7. REMOVE REAR SEATBACK ASSEMBLY LH 

    Refer to PROCEDURE - Step 6

  8. REMOVE QUARTER INSIDE TRIM BOARD LH 

    Refer to PROCEDURE - Step 18

  9. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH 

    See step  4

  10. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 10

  11. REMOVE OUTER LAP BELT ANCHOR COVER 
    1. Place your hands at the positions shown in the illustration and pull in the removal direction (1) to detach guide A.
      GTY822540Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Guide A
      *b Guide B
      Remove in this Direction (1)
      Remove in this Direction (2)
    2. Slide in the removal direction (2) shown in the illustration to detach guide B and remove the outer lap belt anchor cover.
  12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) 
    1. Remove the bolt and floor anchor of the front seat outer belt assembly LH.
      GTY802236Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE QUARTER TRIM PANEL ASSEMBLY LH 

    Refer to PROCEDURE - Step 22

  14. REMOVE CENTER PILLAR GARNISH ASSEMBLY LH 

    Refer to PROCEDURE - Step 24

  15. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH 
    1. Remove the bolt and shoulder anchor of the front seat outer belt assembly LH.
      GTY802237Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

      HINT: 

      Tape the screwdriver tip before use.

      GTY836308Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Locking Button
      *b Release
      Protective Tape
    3. Disconnect the tension reducer connector.
    4. Remove the 2 bolts.
      GTY802523Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Detach the guides and remove the front seat outer belt assembly LH.
  16. REMOVE FRONT SEAT BELT RETRACTOR COVER LH 
    1. Pull in the removal direction (1) shown in the illustration to detach the claw.
      GTY775642Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1)
      Remove in this Direction (2)
    2. Slide in the removal direction (2) shown in the illustration to detach the guide and remove the front seat belt retractor cover LH.
scientia non olet · About LEMON Manuals