Removal [03/2017 - 05/2023]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [03/2017 - 05/2023]
REMOVE NO. 2 DECK BOARD
Refer to PROCEDURE - Step 11 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 12 [01/2021 - 05/2023]

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Refer to PROCEDURE - Step 2

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.
Refer to PRECAUTION [03/2017 - 04/2020] , or refer to PRECAUTION [04/2020 - 05/2023]
If the airbag deploys for any reason, it may cause a serious accident.

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [03/2017 - 04/2020] , or refer to INITIALIZATION [04/2020 - 05/2023]

REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
Refer to REMOVAL [03/2017 - 05/2023]
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Refer to PROCEDURE - Step 5
REMOVE NO. 1 RADIO BRACKET
Refer to PROCEDURE - Step 7
REMOVE NO. 2 RADIO BRACKET
Refer to PROCEDURE - Step 8

REMOVE NO. 1 NAVIGATION WIRE

Disconnect the 2 connectors and remove the No. 1 navigation wire and navigation ECU.

REMOVE NO. 1 WIRING HARNESS CLAMP BRACKET

Remove the screw.

Detach the guide and remove the No. 1 wiring harness clamp bracket.

REMOVE NAVIGATION ECU