Removal [09/2022 - ]: Procedure

PRECAUTION
for HV Model: Refer to PRECAUTION [09/2022 - ]

for Gasoline Model: Refer to PRECAUTION [09/2022 - ]
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 1
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 2
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
for UA80E:

Refer to PROCEDURE - Step 1

for P710:

Refer to PROCEDURE - Step 1

for UB80F:

Refer to PROCEDURE - Step 1
REMOVE FRONT CONSOLE BOX COVER
Refer to PROCEDURE - Step 4
REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
REMOVE LOWER INSTRUMENT PANEL
Refer to PROCEDURE - Step 17
REMOVE FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 4
REMOVE COWL SIDE TRIM BOARD RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 5
REMOVE FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 6
REMOVE INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 22
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 23
REMOVE LOWER INSTRUMENT PANEL LH
Refer to PROCEDURE - Step 25
REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 26
REMOVE RADIO RECEIVER ASSEMBLY WITH SWITCH
Refer to PROCEDURE - Step 16

REMOVE DCM (TELEMATICS TRANSCEIVER) WITH BRACKET

Remove the 2 nuts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect each connector and remove the DCM (telematics transceiver) with bracket.

REMOVE TELEPHONE BRACKET

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the screw and telephone bracket.

REMOVE NO. 1 TELEPHONE BRACKET

Remove the screw and No. 1 telephone bracket.