Removal [09/2015 - ]: Procedure
- REMOVE UPPER RADIATOR SUPPORT SEAL
Refer to PROCEDURE - Step 3
- REMOVE V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
- DISCHARGE FUEL SYSTEM PRESSURE
(Refer to PRECAUTION [09/2015 - ] )
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - ] ).
- REMOVE AIR CLEANER HOSE ASSEMBLY
Refer to PROCEDURE - Step 10
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
- REMOVE NO. 3 ENGINE COVER
- DISCONNECT NO. 2 FUEL TUBE
- Disconnect the No. 2 fuel tube from the fuel pressure regulator (Refer to PRECAUTION [09/2015 - ]
).
- Disconnect the No. 2 fuel tube from the fuel pressure regulator (Refer to PRECAUTION [09/2015 - ]
).
- DISCONNECT NO. 1 FUEL TUBE
RH Side:
Disconnect the No. 1 fuel tube from the fuel delivery pipe RH (for metallic type) (Refer to PRECAUTION [09/2015 - ] ).
- SST: 09268-21011
LH Side:
Disconnect the No. 1 fuel tube from the fuel delivery pipe LH (Refer to PRECAUTION [09/2015 - ] ).
- DISCONNECT NO. 1 FUEL HOSE
- Disconnect the No. 1 fuel hose from the fuel delivery pipe sub-assembly LH (Refer to PRECAUTION [09/2015 - ]
).
- Disconnect the No. 1 fuel hose from the fuel delivery pipe sub-assembly LH (Refer to PRECAUTION [09/2015 - ]
).
- REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY RH
- REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY LH
- REMOVE FUEL INJECTOR ASSEMBLY
- Remove the fuel injector assembly from the fuel delivery pipe, and then disconnect the injector connector.TEXT IN ILLUSTRATION
*a No. 1 - Remove the O-ring from the fuel injector assembly.TEXT IN ILLUSTRATION
*1 O-ring - Detach the 3 clamps and then remove the No. 6 wire harness from the delivery pipe sub-assembly RH.
- Detach the 3 clamps and then remove the No. 7 wire harness from the delivery pipe sub-assembly LH.
- Remove the fuel injector assembly from the fuel delivery pipe, and then disconnect the injector connector.