Removal [10/2017 - 09/2018]: Procedure
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
- REMOVE TOOL BOX
Refer to PROCEDURE - Step 2
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [10/2017 - 09/2019]
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to PROCEDURE - Step 3
- REMOVE AUXILIARY BATTERY
Refer to REMOVAL [10/2017 - 09/2018]
- REMOVE LUGGAGE COMPARTMENT FLOOR MAT
Refer to PROCEDURE - Step 23
- REMOVE LUGGAGE COMPARTMENT TRIM COVER LH
Refer to PROCEDURE - Step 25
- REMOVE LUGGAGE COMPARTMENT TRIM COVER RH
Refer to PROCEDURE - Step 26
- REMOVE SIDE TRIM BOX
Refer to PROCEDURE - Step 14
- REMOVE ROPE HOOK ASSEMBLY
Refer to PROCEDURE - Step 10
- REMOVE REAR FLOOR FINISH PLATE
Refer to PROCEDURE - Step 11
- REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 28
- REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 29
- REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 31
- REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH
Refer to PROCEDURE - Step 15
- REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH
Refer to PROCEDURE - Step 12
- REMOVE REAR LUGGAGE COMPARTMENT TRAY BRACKET RH
See step 17
- REMOVE BATTERY CARRIER CATCH BRACKET SUB-ASSEMBLY
- REMOVE BATTERY CARRIER ASSEMBLY
- REMOVE CONNECTOR COVER
See step 18
- REMOVE LUGGAGE ROOM RELAY BLOCK
- Loosen the nut and disconnect the positive (+) terminal of the sub-battery from the sub-battery module assembly.
- Remove the 2 bolts from the luggage room relay block.
- Detach the clamp and claw and disconnect the luggage room relay block.
- Remove the relay block cover.
- Lift up the lock lever and disconnect the connector as shown in the illustration.
- Detach the 3 clamps and disconnect the luggage room relay block harness from the luggage room panel.
- Detach the 2 clamps and disconnect the luggage room relay block harness from the luggage room panel.
- w/ Dynamic Rear Steering:
- REMOVE BACKUP RELAY
- Detach the clamp and disconnect the 3 tie wraps from the luggage room relay block.
*a Luggage Room Relay Block Lower Side - Detach the 6 claws and remove the relay block lower cover from the luggage room relay block.
*a Luggage Room Relay Block Lower Side - Detach the 3 claws and disconnect the relay block assembly from the luggage room relay block.
*a Luggage Room Relay Block Upper Side - Loosen the bolt and nut and remove them from the backup relay terminal.
*a Backup Relay Terminal Side - Loosen the 2 bolts and remove them from the backup relay.
- Disconnect the connector from the backup relay.
- Detach the claw and remove the backup relay from the relay block assembly.
- Detach the clamp and disconnect the 3 tie wraps from the luggage room relay block.