LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500 Base, RWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - Service Information (2 Of 4) >> REAR SEAT SIDE AIRBAG ASSEMBLY (for Power Seat) >> Removal [10/2022 - 10/2023] >> Procedure

Removal [10/2022 - 10/2023]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    Refer to PRECAUTION [11/2021 - 10/2023]

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After the engine switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

    Refer to PRECAUTION [10/2020 - 10/2023]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

    WARNING:
    • Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD LH 

    Refer to REMOVAL [10/2022 - 10/2023]

  5. REMOVE REAR SEAT AIRBAG ASSEMBLY LH 
    WARNING:
    • When storing the rear seat airbag assembly LH, keep the airbag deployment side facing upward.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY829740Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    Deployment Side
    1. Detach the claw and disconnect the airbag connector.
      GTY814949Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts and rear seat airbag assembly LH.
      WARNING:
      • Do not reuse the nut.
      • If the installation surface or surrounding area of the rear seat airbag assembly LH is deformed or damaged, replace the rear seat sub panel sub-assembly LH with a new one.
scientia non olet · About LEMON Manuals