LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LS 500 Base, RWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock System - Service Information >> Door Control Receiver >> Removal [10/2020 - 10/2022] >> Procedure

Removal [10/2020 - 10/2022]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [10/2020 - 10/2022]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

  4. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 

    Refer to PROCEDURE - Step 24

  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH 

    Refer to PROCEDURE - Step 26

  6. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH 

    Refer to PROCEDURE - Step 27

  7. REMOVE TOOL BOX 

    Refer to PROCEDURE - Step 28

  8. REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 29

  9. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 30

  10. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 1

  11. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 32

  12. REMOVE ROPE HOOK ASSEMBLY 

    Refer to PROCEDURE - Step 10

  13. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 11

  14. REMOVE SIDE TRIM BOX 
    1. Detach the claw and guide and remove the side trim box as shown in the illustration.
      GTY804875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  15. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH 
    1. Push the lever in the direction of the arrow shown in the illustration and remove the rope hook.
      GTY807605Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Push
    2. Remove the grommet.
      GTY815839Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Clip
      Grommet
    3. Using a clip remover, remove the 2 clips and luggage compartment trim cover assembly RH.
  16. REMOVE ELECTRICAL KEY AND TPMS RECEIVER ASSEMBLY 
    1. Remove the nut.
      GTY821368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Nut
      Connector
    2. Disconnect the 2 connectors and remove the electrical key and TPMS receiver assembly.
      NOTE:
      • Do not subject the electrical key and TPMS receiver assembly to strong impacts or force, and do not drop it.
      • If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.
        GTY833118Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals