Removal [12/2017 - 09/2018]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
Refer to PRECAUTION [12/2017 - 10/2020]
NOTE:After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [12/2017 - 10/2020]
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- Disconnect the cable from the negative (-) battery terminal.
Refer to PROCEDURE - Step 3
WARNING:- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [12/2017 - 09/2018]
- Disconnect the cable from the negative (-) battery terminal.
- REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY
Refer to REMOVAL [12/2017 - 09/2018]
- REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY
Refer to PROCEDURE - Step 11
- REMOVE NO. 1 HEATER TO REGISTER DUCT
Refer to PROCEDURE - Step 12
- REMOVE NO. 1 CLEARANCE WARNING BUZZER