LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Coupe >> Repair and Diagnosis >> Body & Frame >> Seats >> Seats - Service Information (Coupe) (2 Of 2) >> Limit Switch >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  2. REMOVE FRONT SEAT ASSEMBLY LH 

    Refer to REMOVAL [05/2023 - ]

  3. REMOVE FRONT SEAT CUSHION SHIELD LH 

    Refer to PROCEDURE - Step 6

  4. REMOVE LH SEAT FRONT OUTER SEATBACK EDGE PROTECTOR (LIMIT SWITCH) (for Outer Side) 
    1. Disconnect the connector.
      GTY817750Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Connector
      Screw
      Remove in this Direction
    2. Remove the 2 screws.
    3. Pull in the removal direction shown in the illustration to detach the guides and remove the limit switch assembly.
  5. REMOVE FRONT INNER SEAT CUSHION SHIELD LH 

    Refer to PROCEDURE - Step 13

  6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY 

    Refer to PROCEDURE - Step 15

  7. REMOVE SEAT ADJUSTER COVER CAP LH 

    Refer to PROCEDURE - Step 16

  8. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 17

  9. REMOVE FRONT SEATBACK SUB-ASSEMBLY LH (for Standard Seat Type) 

    Refer to PROCEDURE - Step 19

  10. REMOVE FRONT SEAT HEADREST SUPPORT (for Standard Seat Type) 

    Refer to PROCEDURE - Step 20

  11. REMOVE FRONT SEAT HEADREST SUPPORT (for Sports Seat Type) 

    Refer to PROCEDURE - Step 21

  12. REMOVE FRONT UPPER SEATBACK COVER SUB-ASSEMBLY LH (for Standard Seat Type) 

    Refer to PROCEDURE - Step 22

  13. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Standard Seat Type) 

    Refer to PROCEDURE - Step 23

  14. REMOVE FRONT SEATBACK PAD WITH COVER LH (for Sports Seat Type) 

    Refer to PROCEDURE - Step 26

  15. REMOVE SEAT RECLINING ADJUSTER INSIDE COVER LH 

    Refer to PROCEDURE - Step 27

  16. REMOVE LH SEAT FRONT INNER SEATBACK EDGE PROTECTOR (LIMIT SWITCH) (for Inner Side) 
    1. Disconnect the connector.
      GTY785474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Connector
      Screw
      Remove in this Direction
    2. Remove the screw.
    3. Pull in the removal direction shown in the illustration to detach the guides and remove the limit switch assembly.