Installation [03/2017 - ]: Procedure

INSTALL REAR SEATBACK ASSEMBLY LH

Place the rear seatback assembly LH in the vehicle.
NOTE:
Do not damage the rear seatback assembly LH, body and body interior.

Temporarily install the rear seatback assembly LH to the stud bolt.

Fig 1: Rear Seatback Assembly LH Bolts And Nut With Tightening Sequence

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Nut
	Bolt
	Install in this Direction

Temporarily install the nut and 2 bolts.
Tighten the nut and 2 bolts in the order shown in the illustration.
Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)

INSTALL REAR SEATBACK ASSEMBLY RH
HINT:

Use the same procedure described for the LH side.

INSTALL REAR SEATBACK COVER

HINT:

Use the same procedure for the other side.

Attach the clips to install the rear seatback cover.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

INSTALL REAR SEAT SIDE GARNISH
Refer to PROCEDURE - Step 7

INSTALL REAR SEAT CUSHION HOLDER BRACKET

HINT:

Use the same procedure for the other side.

Install the rear seat cushion holder bracket with the bolt.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)

INSTALL REAR SEAT CUSHION LOCK HOOK

HINT:

Use the same procedure for the other side.

Set a new rear seat cushion lock hook in place.

Using 2 thin-bladed screwdrivers, push the sleeve to attach the claws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Sleeve
*b	Protective Tape

NOTE:

Do not apply excessive force which may break the sleeve.

HINT:

Tape the thin-bladed screwdriver tip before use.

Check the installation condition.

The sleeve is installed properly.

*a	Body	*b	Vehicle
*c	Sleeve	*d	Correct
*e	Incorrect	-	-

INSTALL REAR SEAT CUSHION ASSEMBLY

Place the rear seat cushion assembly in the vehicle.
NOTE:
Do not damage the rear seat cushion assembly, body and body interior.

Attach the hooks on the rear of the rear seat cushion assembly to the 2 child restraint seat anchor brackets.

*1	Child Restraint Seat Anchor Bracket
*a	Hook on Rear of Rear Seat Cushion
	Install in this Direction

Push in the installation direction shown in the illustration and attach the 2 hooks on the front of the rear seat cushion assembly to the 2 rear seat cushion lock hooks to install the rear seat cushion assembly.

*1	Rear Seat Cushion Lock Hook
*a	Hook on Front of Rear Seat Cushion
	Install in this Direction

NOTE:

Attach the rear seat cushion front side hooks one at a time.
Check that the rear seat cushion lock hooks and rear seat cushion assembly are securely fastened.