Removal [07/2020 - 05/2023]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
Refer to PRECAUTION [07/2020 - 05/2023]
NOTE:After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Refer to PRECAUTION [07/2020 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to REMOVAL [07/2020 - 05/2023]
WARNING:- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [07/2020 - 05/2023]
- REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to REMOVAL [07/2020 - 10/2022] , or refer to REMOVAL [10/2022 - 05/2023]
- REMOVE NO. 3 HEATER TO REGISTER DUCT
Refer to PROCEDURE - Step 2
- REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
- REMOVE NO. 3 INSTRUMENT PANEL WIRE
- Disconnect the 2 airbag connectors.NOTE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
HINT:
Refer to How to Connect or Disconnect Airbag Connector:
Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [07/2020 - 05/2023]
- Detach the wire harness clamp and remove the No. 3 instrument panel wire.
- Disconnect the 2 airbag connectors.