LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating / Air Conditioning System - Service Information (Convertible) (2 Of 2) >> Air Conditioning Panel >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

  1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM 

    Refer to PROCEDURE - Step 2

  2. REMOVE COMBINATION METER ASSEMBLY 

    Refer to REMOVAL [07/2020 - ]

  3. REMOVE INSTRUMENT PANEL SAFETY PAD COVER 

    Refer to PROCEDURE - Step 3

  4. REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD COVER 

    Refer to PROCEDURE - Step 4

  5. REMOVE MULTI-DISPLAY WITH BRACKET 

    Refer to PROCEDURE - Step 5

  6. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 9

  7. REMOVE FRONT DOOR OPENING TRIM COVER LH 

    Refer to PROCEDURE - Step 11

  8. REMOVE FRONT DOOR NO. 2 OPENING TRIM COVER LH 

    Refer to PROCEDURE - Step 13

  9. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 15

  10. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY 

    Refer to REMOVAL [07/2020 - ]

  11. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  12. REMOVE SHIFTING HOLE COVER ASSEMBLY 

    Refer to PROCEDURE - Step 4

  13. REMOVE UPPER CONSOLE BOX 

    Refer to PROCEDURE - Step 7

  14. REMOVE NO. 1 GLOVE COMPARTMENT PANEL 

    Refer to PROCEDURE - Step 16

  15. REMOVE BOX PANEL SUB-ASSEMBLY 
    1. Remove the 3 bolts and 2 screws.
      GTY787389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Screw
    2. Hold the area shown in the illustration and detach the clip while pulling towards the exterior of the vehicle.
      GTY963757Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction
    3. Hold the area shown in the illustration and detach the clip while pulling towards the exterior of the vehicle.
      GTY964100Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction
    4. Hold the area shown in the illustration, detach the claw and remove the box panel sub-assembly.
      GTY838427Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction
  16. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 
    1. Move the front seat (RH side) to the rearmost position and remove the 2 bolts and 2 screws.
      GTY778935Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Screw
    2. Remove the bolt.
      GTY817912Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Fold the front seatback (RH side) forward, hold the area shown in the illustration and detach the clip and claw while pulling towards the exterior of the vehicle.
      GTY964314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction
    4. Hold the area shown in the illustration while pulling it towards, the rear of the vehicle, detach the claw and then pull out the guide from the instrument panel.
      GTY963552Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction
    5. Return the front seatback (RH side) to the original position, hold the area shown in the illustration and detach the claw while pulling towards the exterior of the vehicle.
      GTY963397Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction
    6. Pull diagonally to the upper rear of the vehicle as indicated by the arrows shown in the illustration to remove the upper console panel sub-assembly.
      NOTE:

      A portion of the claw is inserted into mating hole. Therefore, hold the area shown in the illustration and remove it while lifting the claw towards the outside of the vehicle.

      GTY814507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction (1)
      Remove in this Direction (2)
  17. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 21

  18. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22

  19. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 23

  20. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  21. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY 
    1. Place your hand at the position shown in the illustration and pull the integration control and panel assembly towards the rear of the vehicle to detach the claw and clip and remove it.
      GTY963287Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hands Here
      Remove in this Direction
    2. Using a thin-bladed screwdriver, detach the clamp and disconnect the 3 connectors.
      GTY964389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals