Installation [07/2020 - 05/2023]: Procedure

INSTALL METER MIRROR SUB-ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Bolt
	Connector

Connect the connector.

INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to INSTALLATION [07/2020 - 10/2022] , or refer to INSTALLATION [10/2022 - 05/2023]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to INSTALLATION [07/2020 - 05/2023]

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [07/2020 - 05/2023]
INSTALL NO. 2 DECK BOARD
Refer to PROCEDURE - Step 13 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 13 [10/2022 - 05/2023]
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Refer to PROCEDURE - Step 23 [07/2020 - 05/2023]
CHECK SRS WARNING LIGHT
Refer to OPERATION CHECK [07/2020 - ]
ADJUST PARKING ASSIST MONITOR SYSTEM
Refer to CALIBRATION [07/2020 - 05/2023]