Removal [07/2022 - ]: Procedure

See step  1

Refer to REMOVAL [07/2022 - ]

1. Disconnect the engine room main wire.

   Refer to PROCEDURE - Step 11

2. Remove the connector cover assembly.

   Refer to PROCEDURE - Step 12

3. Check the terminal voltage.

   Refer to PROCEDURE - Step 13

4. Install the connector cover assembly.

   Refer to PROCEDURE - Step 6

5. Connect the engine room main wire.

   Refer to PROCEDURE - Step 16

Refer to PROCEDURE - Step 5

1. Remove the bolt to disconnect the discharge hose sub-assembly from the compressor with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the refrigerant discharge hose sub-assembly.
   NOTE:

   Wrap protective tape around the connecting portions of the disconnected refrigerant discharge hose sub-assembly and compressor with motor assembly to prevent contamination by foreign matter or water droplets.

1. Remove the bolt to disconnect the suction hose sub-assembly from the compressor with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the suction hose sub-assembly.
   NOTE:

   Wrap protective tape around the connecting portions of the disconnected suction hose sub-assembly and the compressor with motor assembly to prevent contamination by foreign matter or water droplets.

1. Slide the green-colored lock of the connector A as shown in the illustration to release it and disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Connector A
   *b	Connector B
   *c	Green-colored Lock

   WARNING:

   Make sure to wear insulating gloves.

   NOTE:

   Insulate the disconnected terminals and connector with insulating tape.

2. Disconnect the connector B.
3. Remove the 3 bolts and compressor with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002