Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL BATTERY STATE SENSOR ASSEMBLY
- Install the battery state sensor assembly to the battery current sensor holder shown in the illustration.
Install in this Direction - Engage the 2 claws to close the battery state sensor assembly shown in the illustration.
Close - Engage the clamp and connect the battery state sensor assembly connector.
- Install the battery state sensor assembly to the auxiliary battery and tighten the nut.
Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
- Engage the clamp and install the auxiliary battery hose.
- Connect the earth wire to the battery state sensor assembly with the nut.
Torque: 7.6 N.m (77 kgf/cm, 67 in.lbf)
NOTE:When disconnecting the earth wire, some systems need to be initialized after the earth wire is reconnected.
Refer to INITIALIZATION [10/2018 - 07/2022] , or refer to INITIALIZATION [07/2022 - ]
- Install the battery state sensor assembly to the battery current sensor holder shown in the illustration.
- INSTALL DECK FLOOR BOX RH
Refer to PROCEDURE - Step 3
- INSTALL LUGGAGE COMPARTMENT TRIM BOX
Refer to PROCEDURE - Step 4
- INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 5