LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Hybrid Control System (Diagnostic Codes) (3 Of 5)) >> Hybrid Control System >> DTC P1C87-79: Generator Mechanical Linkage Failure; DTC P1C8879: Planetary Gear Mechanical Linkage Failure [10/2018 - ] >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [10/2018 - ]

DTC P1C8779 

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 2 minutes or more.
  5. Turn the power switch on (IG) and turn the Techstream on.
  6. Turn the power switch on (READY).
  7. Drive the vehicle at approximately 30 km/h (19 mph) or more for approximately 10 seconds or more while maintaining a stable vehicle speed.

    (If generator (MG1) does not rotate in this condition, DTC P1C8779 will be stored.)

  8. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
  9. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.

DTC P1C8879 

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 2 minutes or more.
  5. Turn the power switch on (IG) and turn the Techstream on.
  6. When the vehicle is stopped, turn the power switch on (READY) and gradually depress the accelerator pedal so that the engine starts.
  7. Drive the vehicle at approximately 30 km/h (19 mph) or more for approximately 10 seconds or more while maintaining the vehicle speed.
  8. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
  9. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.
scientia non olet · About LEMON Manuals