DTC P1C86-79: Transmission (Input) Mechanical Linkage Failure [10/2018 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check for DTCs.

   Powertrain > Hybrid Control > Trouble Codes 

   Result

   Result	Proceed to
   P1C8679 only is output, or DTCs except the ones in the table below are also output.	A
   Any of the following DTCs including pending DTCs are also output.	B

   Malfunction Content	Relevant DTC
   Sensor and actuator circuit malfunction	P1C8779	Generator Mechanical Linkage Failure
   	P1C8879	Planetary Gear Mechanical Linkage Failure

   HINT: 

   P1C8679 may be output as a result of the malfunction indicated by the DTCs above.

5. Turn the power switch off.

Result: 

B 

GO TO DTC CHART (HYBRID CONTROL SYSTEM). Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2018 - ] 

Result: 

A 

See step  2

See step  1

Result

Result: 

NG 

See step  7

Result: 

OK 

See step  3

See step  2

Result

Result: 

NEXT 

See step  4

See step  3

Result

Result: 

NG 

REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

OK 

See step  5

See step  4

Result

Result: 

NG 

REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

OK 

See step  6

See step  5

Result

Result: 

A 

REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

B 

REPLACE TRANSMISSION INPUT DAMPER ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

See step  6

Result

Result: 

OK 

REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

Result: 

NG 

REPAIR OR REPLACE ENGINE