LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Hybrid Control System (Diagnostic Codes) (3 Of 5)) >> Hybrid Control System >> DTC P1A80-00: Hybrid/EV Battery Stack 1 Delta SOC High; DTC P1AD01B: Hybrid/EV Battery Block Circuit Resistance Above Threshold [10/2018 - ] >> Procedure

DTC P1A80-00: Hybrid/EV Battery Stack 1 Delta SOC High; DTC P1AD01B: Hybrid/EV Battery Block Circuit Resistance Above Threshold [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC OUTPUT (HYBRID CONTROL) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
    4. Check and record any HV system DTCs and freeze frame data.

      Powertrain > Hybrid Control > Trouble Codes 

      Result

      Result Proceed to
      "P0AFC00, P0AFC96, P308A12 or P0AFC62" is not output. A
      "P0AFC00, P0AFC96, P308A12 or P0AFC62" is also output. B
    5. Turn the power switch off.

    Result: 

    GO TO DTC CHART (HYBRID CONTROL SYSTEM). Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2018 - ] 

    Result: 

    See step  2

  2. CHECK FREEZE FRAME DATA 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

      Powertrain > Hybrid Control > Trouble Codes 

    4. Using the Techstream, make a note of the freeze frame data item "Number of Hybrid Battery Current Sensor Characteristics Determination".

      Result

      Result Proceed to
      0 to 99 A
      Other than above B
    5. Turn the power switch off.
    6. Disconnect the Techstream from the DLC3.

    Result: 

    REPLACE HV BATTERY JUNCTION BLOCK ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

    Result: 

    See step  3

  3. CHECK TOTAL DISTANCE DRIVEN 
    1. Read the odometer to check the total distance the vehicle has been driven.

      Result

      Result Proceed to
      Total distance driven is less than 200000 km (124280 mile) A
      Total distance driven is 200000 km (124280 mile) or more Current total distance driven - total distance driven when hybrid battery terminal block replaced = less than 200000 km (124280 mile) *1
      Other than above B

      HINT: 

      *1: If the hybrid battery terminal block has been replaced, use the total distance driven since it was replaced.

    Result: 

    REPLACE HV BATTERY. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ] 

    Result: 

    See step  4

  4. REPLACE HV BATTERY 

    Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]

    Result

    Proceed to
    NEXT

    Result: 

    NEXT 

    REPLACE HYBRID BATTERY TERMINAL BLOCK. Refer to  REMOVAL [10/2018 - 07/2022]  Refer to  REMOVAL [07/2022 - ]