LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Lubrication System (M20A-FXS) (Service Information)) >> Oil Level Sensor >> Removal [10/2018 - ] >> Procedure

Removal [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 6 [10/2018 - 07/2022] , or refer to PROCEDURE - Step 5 [07/2022 - ]

  2. DRAIN ENGINE OIL 

    Refer to PROCEDURE - Step 2

  3. REMOVE OIL PAN SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 49

  4. REMOVE ENGINE OIL LEVEL SENSOR 
    1. Disconnect the engine oil level sensor connector.
    2. Remove the clip from the engine oil level sensor.
      GTY787475Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using an 8 mm socket wrench, remove the 2 bolts and engine oil level sensor from the engine balancer assembly.
      GTY787476Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals