Distance Control Switch Circuit [10/2018 - 07/2022]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Radar Cruise 2 / Data List.
5. Read the Data List according to the display on the Techstream.

   Powertrain > Radar Cruise2 > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Vehicle-to-vehicle Distance Control Switch	Vehicle-to-vehicle distance control switch signal	ON or OFF	ON: Vehicle-to-vehicle distance control switch pushed OFF: Vehicle-to-vehicle distance control switch not pushed	-

   Powertrain > Radar Cruise2 > Data List 

   Tester Display
   Vehicle-to-vehicle Distance Control Switch

   OK

   The value of the Data List item changes according to the operation of the vehicle-to-vehicle distance control switch.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2018 - 07/2022] 

Result: 

NG 

See step  2

1. Remove the steering pad switch assembly.

   Refer to REMOVAL [10/2018 - 07/2022]

2. Inspect the steering pad switch assembly.

   Refer to INSPECTION [10/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE STEERING PAD SWITCH ASSEMBLY. Refer to  COMPONENTS [10/2018 - ] 

Result: 

OK 

See step  3

1. Remove the spiral cable sub-assembly.

   Refer to REMOVAL [10/2018 - 07/2022]

2. Inspect the spiral cable sub-assembly.

   Refer to INSPECTION [10/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SPIRAL CABLE SUB-ASSEMBLY. Refer to  COMPONENTS [10/2018 - ] 

Result: 

OK 

See step  4

1. Disconnect the F20 spiral cable sub-assembly connector.
2. Disconnect the S4 forward recognition camera connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F20-6 (DIST) - S4-3 (LKSW)	Always	Below 1 Ω
   F20-2 (ECC) - Body ground	Always	Below 1 Ω
   F20-6 (DIST) or S4-3 (LKSW) - Body ground	Always	10 kΩ or higher

4. Connect the S4 forward recognition camera connector.
5. Connect the F20 spiral cable sub-assembly connector.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE FORWARD RECOGNITION CAMERA. Refer to  COMPONENTS [10/2018 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR