DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
- Replace the cam timing control motor with EDU assembly.
Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]
HINT:
Perform "Inspection After Repair" after replacing the cam timing control motor with EDU assembly.
Refer to INITIALIZATION [10/2018 - 08/2021] Refer to INITIALIZATION [08/2021 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Replace the cam timing control motor with EDU assembly.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the power switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P261401 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [10/2018 - 07/2022] Refer to REMOVAL [07/2022 - ]