Installation [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY

HINT:

Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary.

Engage the 2 claws to install a new leak detection pump sub-assembly to the charcoal canister sub-assembly.

NOTE:

Do not allow foreign matter such as grease, oil or water to adhere to the O-ring.
Ensure that the claws are engaged properly.

INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)
1. Install the clip to the vehicle body.
2. Engage the claw to install the canister (charcoal canister assembly) to the vehicle body as shown in the illustration.
3. Engage the clip to connect the canister (charcoal canister assembly).
4. Install the 2 bolts.
  Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
5. Connect the purge line hose to the canister (charcoal canister assembly) and slide the clip to secure it.
6. Push the fuel tank vent hose onto the canister (charcoal canister assembly) and push in the retainer to engage the lock claws.
  NOTE:
  - Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.
  - After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling on the tube connector.
7. Connect the leak detection pump sub-assembly connector.
8. Push in the fuel tank vent hose sub-assembly onto the leak detection pump sub-assembly and push in the retainer to engage the lock claws.
  NOTE:
  - Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (leak detection pump sub-assembly) before performing this work.
  - After connecting the fuel tank vent hose sub-assembly, check that the fuel tank vent hose sub-assembly is securely connected by pulling on the tube connector.
INSTALL REAR FLOOR SIDE MEMBER COVER LH
Refer to PROCEDURE - Step 21 [10/2018 - 07/2022] , or refer to PROCEDURE - Step 23 [07/2022 - ]
INSTALL NO. 1 FLOOR UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 22 [10/2018 - 07/2022] , or refer to PROCEDURE - Step 24 [07/2022 - ]
INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY (for AWD)
Refer to INSTALLATION [10/2018 - 10/2020] , or refer to INSTALLATION [10/2020 - ]
INSTALL TAIL EXHAUST PIPE ASSEMBLY
Refer to PROCEDURE - Step 3
INSPECT FOR EXHAUST GAS LEAK
Refer to PROCEDURE - Step 7