Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [10/2018 - 08/2021] Refer to INITIALIZATION [08/2021 - ]
- Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
- Install the engine coolant temperature sensor to the water outlet with a new clip.NOTE:
- If the engine coolant temperature sensor has been struck or dropped, replace it.
- If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.
- If the O-ring has been damaged, replace the engine coolant temperature sensor with a new one.
- Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.
- Connect the engine coolant temperature sensor connector.
- Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
- INSTALL INVERTER WITH CONVERTER ASSEMBLY
Refer to INSTALLATION [10/2018 - ]
- ADD ENGINE COOLANT
Refer to PROCEDURE - Step 3 Refer to PROCEDURE - Step 3
- INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 1 Refer to PROCEDURE - Step 1
- INSTALL REAR ENGINE UNDER COVER LH
Refer to PROCEDURE - Step 5 Refer to PROCEDURE - Step 5
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [10/2018 - 08/2021] Refer to INITIALIZATION [08/2021 - ]
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.