LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Control System (SFI) (M20A-FXS) - Diagnostic Codes (1 Of 6) (Hybrid)) >> SFI System >> DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [10/2018 - ] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
Monitor runs whenever the following DTCs are not stored P0010, P1360, P1362, P1364, P1366, P2614 (Motor drive VVT system control module)
P0016 (VVT system - misalignment)
P0101, P0102, P0103 (Mass air flow meter)
P0107, P0108 (Manifold absolute pressure)
P0117, P0118 (Engine coolant temperature sensor)
P0125 (Insufficient engine coolant temperature for closed loop fuel control)
P0335, P0337, P0338 (Crankshaft position sensor)
P0340, P0342, P0343 (Camshaft position sensor)
P0365, P0367, P0368 (Exhaust camshaft position sensor)
Auxiliary battery voltage 11 V or higher
Engine speed 500 to 4000 rpm
Engine coolant temperature 75 to 120°C (167 to 248°F)
scientia non olet · About LEMON Manuals