LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display (Service Information) >> Combination Meter >> Removal [07/2022 - ] >> Procedure

Removal [07/2022 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to INITIALIZATION [07/2022 - ]

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column) 

    Refer to CUSTOMIZE PARAMETERS [10/2018 - ]

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to REMOVAL [07/2022 - ]

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [07/2022 - ]

  4. REMOVE MULTI-DISPLAY 

    Refer to REMOVAL [07/2022 - ]

  5. REMOVE INSTRUMENT PANEL HOLE COVER 

    Refer to PROCEDURE - Step 21

  6. REMOVE NO. 2 INSTRUMENT PANEL HOLE COVER 

    Refer to PROCEDURE - Step 22

  7. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 4 screws.
      GTY812692Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guides.
    3. Disengage the clamp.
      GTY835506Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the 2 connectors to remove the combination meter assembly.
scientia non olet · About LEMON Manuals