Installation [03/2018 - ]: Procedure

INSTALL COMBINATION METER ASSEMBLY
1. Connect each connector.
2. Engage the clamp.
3. Install the combination meter assembly with the 4 screws.

INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Connect the connector.

Engage the 7 clips as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

Engage the 4 clips and 2 claws to install the instrument cluster finish panel sub-assembly.

INSTALL LOWER INSTRUMENT FINISH PANEL SUB
Refer to PROCEDURE - Step 32 [03/2018 - 08/2019] Refer to PROCEDURE - Step 29 [08/2019 - ]
INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Refer to PROCEDURE - Step 5 [12/2017 - 08/2019] Refer to PROCEDURE - Step 5 [08/2019 - ]
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 7 [12/2017 - 08/2019] Refer to PROCEDURE - Step 7 [08/2019 - ]
INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 8 [12/2017 - 08/2019] Refer to PROCEDURE - Step 8 [08/2019 - ]
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 33 [03/2018 - 08/2019] Refer to PROCEDURE - Step 30 [08/2019 - ]
CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 34 [03/2018 - 08/2019] Refer to PROCEDURE - Step 31 [08/2019 - ]
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 35 [03/2018 - 08/2019] Refer to PROCEDURE - Step 32 [08/2019 - ]
INSTALL COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 2
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 42
INSTALL INSTRUMENT PANEL GARNISH LH
Refer to PROCEDURE - Step 38 [03/2018 - 08/2019] Refer to PROCEDURE - Step 35 [08/2019 - ]
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
w/o Rear No. 2 Seat:

Refer to PROCEDURE - Step 2

w/ Rear No. 2 Seat:

Refer to PROCEDURE - Step 2
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Refer to CUSTOMIZE PARAMETERS [10/2015 - ]
INSTALL BATTERY SERVICE HOLE COVER (w/ Rear No. 2 Seat)
Refer to PROCEDURE - Step 59
INSTALL REAR NO. 4 FLOOR BOARD (w/ Rear No. 2 Seat)
Refer to PROCEDURE - Step 60
INSTALL REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 53
INSTALL DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
Refer to PROCEDURE - Step 55