Installation [10/2015 - ]: Procedure

1. w/ Battery Insulator:
   1. Install the battery insulator to the auxiliary battery.
2. Install the auxiliary battery.
3. Connect the battery hose to the auxiliary battery.

   HINT: 

   Push the battery hose onto the auxiliary battery until a click sound is heard.

4. Install the battery clamp sub-assembly with the 2 nuts.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

5. Connect the cable to the positive (+) auxiliary battery terminal and tighten the nut.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

6. Close the battery terminal cap.

1. Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   NOTE:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Refer to INITIALIZATION [10/2015 - 08/2016] , or refer to INITIALIZATION [08/2016 - 12/2017] , or refer to INITIALIZATION [12/2017 - 03/2018] , or refer to INITIALIZATION [03/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - ]

Refer to PROCEDURE - Step 54 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 53 [12/2017 - ]

Refer to PROCEDURE - Step 56 [10/2015 - 12/2017] , or refer to PROCEDURE - Step 55 [12/2017 - ]