LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 450h Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Service Information) (1 Of 2) >> Fog Light Assembly >> Removal [03/2018 - 08/2019] >> Procedure

Removal [03/2018 - 08/2019]: Procedure

  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD 

    HINT: 

    Use the same procedure as for the RH side.

    Refer to PROCEDURE - Step 3

  2. DISCONNECT FRONT FENDER MOLDING SUB-ASSEMBLY (for TMMC Made) 

    Refer to PROCEDURE - Step 2

  3. REMOVE FOG LIGHT ASSEMBLY 
    1. Turn the steering wheel fully to the right.

      HINT: 

      When removing the fog light assembly RH, turn the steering wheel to the left.

    2. except TMMC Made:
      1. Remove the 3 clips and separate the front fender splash shield sub-assembly.
        GTY655317Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. for TMMC Made:
      1. Remove the clip and separate the front fender splash shield sub-assembly.
        GTY628145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the connector.
      GTY656044Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the 2 screws.
      GTY656045Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Disengage the 2 guides to remove the fog light assembly.
scientia non olet · About LEMON Manuals