LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> RX 350L FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (1 Of 2) >> Power Back Door Drive Unit >> Removal [12/2017 - ] >> Procedure

Removal [12/2017 - ]: Procedure

  1. REMOVE BACK WINDOW UPPER PANEL TRIM (w/o Rear No. 2 Seat) 

    See step  1, or see step  1

  2. REMOVE BACK WINDOW UPPER PANEL TRIM (w/ Rear No. 2 Seat) 

    See step  2, or see step  2

  3. REMOVE BACK DOOR TRIM COVER LH (w/o Rear No. 2 Seat) 

    See step  3, or see step  3

  4. REMOVE BACK DOOR TRIM COVER LH (w/ Rear No. 2 Seat) 

    See step  4, or see step  4

  5. REMOVE BACK DOOR TRIM COVER RH 

    HINT: 

    Use the same procedure as for the LH side.

  6. REMOVE BACK DOOR LOCK COVER (w/o Rear No. 2 Seat) 

    See step  6, or see step  6

  7. REMOVE BACK DOOR LOCK COVER (w/ Rear No. 2 Seat) 

    See step  7, or see step  7

  8. REMOVE BACK DOOR TRIM BASE 

    See step  8, or see step  8

  9. REMOVE DOOR PULL HANDLE 

    See step  9, or see step  9

  10. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 3 [12/2017 - 08/2019] , or refer to PROCEDURE - Step 3 [08/2019 - ]

  11. REMOVE BACK DOOR TRIM PANEL ASSEMBLY (w/o Rear No. 2 Seat) 

    See step  11, or see step  11

  12. REMOVE BACK DOOR TRIM PANEL ASSEMBLY (w/ Rear No. 2 Seat) 

    See step  12, or see step  12

  13. REMOVE POWER BACK DOOR UNIT SET ASSEMBLY 
    1. Disconnect the connector.
      GTY656341Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Grommet
    2. Disengage the grommet.
    3. Using a screwdriver with its tip wrapped with protective tape, slightly raise the 2 stop rings as indicated by the arrows, in the order shown in the illustration.
      GTY632515Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      Remove in this Direction (1)
      Remove in this Direction (2)
    4. Disengage the 2 ball joints to remove the power back door unit set assembly.
      NOTE:
      • Remove the power back door unit set assembly while supporting the back door by hand.
      • Make sure to replace the power back door unit set assembly with a new one.
  14. REMOVE BACK DOOR DAMPER STAY UPPER BRACKET 
    1. Remove the 2 bolts and back door damper stay upper bracket.
      GTY623264Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE BACK DOOR DAMPER STAY LOWER BRACKET 
    1. Remove the 2 bolts and back door damper stay lower bracket.
      GTY623269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals