Installation [10/2023 - ]: Procedure
- INSTALL HYBRID VEHICLE CONTROL ECU ASSEMBLY
- Install the hybrid vehicle control ECU assembly with the bolt and nut.
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
NOTE:- Do not drop the hybrid vehicle control ECU assembly, strike it with tools or subject it to impact.
- If the hybrid vehicle control ECU assembly is subjected to an impact, replace it with a new one.
- Connect the 3 connectors.
- Install the hybrid vehicle control ECU assembly with the bolt and nut.
- INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 14
- INSTALL GLOVE COMPARTMENT DOOR PAD PLATE
Refer to PROCEDURE - Step 15
- INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 24
- INSTALL LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 32
- INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 35
- INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [10/2023 - ]
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 13
- UPDATE ECU SECURITY KEY
Refer to UPDATE ECU SECURITY KEY [10/2020 - ]
- INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Refer to WORK PROCEDURE [10/2022 - ]
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
- PERFORM RESET MEMORY
If the hybrid vehicle control ECU assembly is replaced, initialize the learning value of the transmission.
Refer to INITIALIZATION [10/2017 - ]