Installation [10/2017 - 10/2020]: Procedure

INSTALL HYBRID VEHICLE CONTROL ECU ASSEMBLY
1. Install the hybrid vehicle control ECU assembly with the bolt and nut.
  Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
  NOTE:
  - Do not drop the hybrid vehicle control ECU assembly, strike it with tools or subject it to impact.
  - If the hybrid vehicle control ECU assembly is subjected to an impact, replace it with a new one.
2. Connect the 4 connectors.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 14
INSTALL GLOVE COMPARTMENT DOOR PAD PLATE
Refer to PROCEDURE - Step 15
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 23
INSTALL LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 30
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 33
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [10/2017 - 10/2020]
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [10/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 10/2020]
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 11
PERFORM RESET MEMORY
If the hybrid vehicle control ECU assembly is replaced, initialize the learning value of the transmission.
- for L310:
  Refer to INITIALIZATION [10/2017 - 10/2023]
- for L310F:
  Refer to INITIALIZATION [10/2017 - ]