LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display - Service Information >> HEADUP Display >> Installation [10/2017 - 10/2020] >> Procedure

Installation [10/2017 - 10/2020]: Procedure

  1. INSTALL HEADUP DISPLAY 
    1. GTY1231127Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Connector

      Connect the connector and temporarily install the headup display.

    2. Install the headup display with the 3 bolts in the order shown in the illustration.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  2. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to INSTALLATION [10/2017 - 10/2020]

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [10/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 10/2020]

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 12

  5. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR [10/2017 - 10/2020]

  6. CHECK SRS WARNING LIGHT 

    Refer to OPERATION CHECK [10/2017 - 10/2020]

  7. PERFORM SYSTEM CALIBRATION 

    Refer to CAUTION / NOTICE / HINT , or refer to REMOVAL [09/2018 - 10/2020] 

scientia non olet · About LEMON Manuals