LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting System (Ext) - Service Information (2 Of 2) >> Stop Light Switch >> Removal [11/2021 - 10/2022] >> Procedure

Removal [11/2021 - 10/2022]: Procedure

  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  2. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    GTY607029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    w/ Advanced Park:

    Refer to PRECAUTION [11/2021 - 10/2023]

    w/o Advanced Park:

    Refer to PRECAUTION [11/2021 - 10/2023]

    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [11/2021 - 10/2022]

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

    WARNING:
    • Wait at least 60 seconds after disconnecting the cable from the negative(-) auxiliary battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to REMOVAL [11/2021 - 10/2022]

  5. REMOVE STOP LIGHT SWITCH ASSEMBLY 
    1. Remove the return spring.
      GTY791146Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector.
      GTY791145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Turn the stop light switch assembly counterclockwise and remove it.
      GTY788700Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Turn in this Direction
  6. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER 
    1. Detach the claw and remove the stop light switch mounting adjuster.
      GTY820789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      NOTE:

      The stop light switch mounting adjuster must not be reused.

scientia non olet · About LEMON Manuals