LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Monitor System - Service Information (3 Of 3) >> Rear Cross Traffic Alert Buzzer >> Removal [11/2021 - 10/2022] >> Procedure

Removal [11/2021 - 10/2022]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    w/ Advanced Park:

    Refer to PRECAUTION [11/2021 - 10/2023]

    w/o Advanced Park:

    Refer to PRECAUTION [11/2021 - 10/2023]

    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [11/2021 - 10/2022]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Refer to PROCEDURE - Step 4

      WARNING:
      • Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
      • If the airbag deploys for any reason, it may cause a serious accident.
      GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. for power seat:

      Refer to REMOVAL [11/2021 - 10/2022]

    2. for fixed seat type:

      Refer to REMOVAL [11/2021 - 10/2022]

  5. REMOVE BLIND SPOT MONITOR BUZZER 
    GTY783485Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the connector.
    2. Using a clip remover, detach the clamp and remove the blind spot monitor buzzer.
scientia non olet · About LEMON Manuals