LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> LS 500h AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Monitor System - Service Information (1 Of 3) >> Clearance Warning Ecu >> Removal [10/2022 - 10/2023] >> Procedure

Removal [10/2022 - 10/2023]: Procedure

  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 

    Refer to PROCEDURE - Step 24

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH 

    Refer to PROCEDURE - Step 26

  4. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH 

    Refer to PROCEDURE - Step 27

  5. REMOVE TOOL BOX 

    Refer to PROCEDURE - Step 28

  6. REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 29

  7. REMOVE ROPE HOOK ASSEMBLY 

    Refer to PROCEDURE - Step 10

  8. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 11

  9. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Advanced Drive) 

    Refer to PROCEDURE - Step 30

  10. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/ Advanced Drive) 

    HINT: 

    Use the same procedure described for the front luggage compartment trim cover (w/o Advanced Drive).

  11. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 1

  12. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER (w/o Advanced Drive) 

    Refer to PROCEDURE - Step 33

  13. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER (w/ Advanced Drive) 

    HINT: 

    Use the same procedure described for the rear luggage compartment trim cover (w/o Advanced Drive).

  14. REMOVE SIDE TRIM BOX 

    Refer to PROCEDURE - Step 16

  15. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH 

    Refer to PROCEDURE - Step 17

  16. REMOVE CLEARANCE WARNING ECU ASSEMBLY 
    1. Disconnect the connector.
      GTY1130179Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Connector
      Nut
    2. Remove the nut.
      NOTE:

      If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.

      GTY833118Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Detach the guide and remove the clearance warning ECU assembly.
  17. REMOVE ECU WATER PROOF COVER 

    HINT: 

    • Perform this procedure only when replacement of the ECU water proof cover is necessary.
    • An ECU water proof cover may not be installed.
    1. Remove the ECU water proof cover.
      GTY1173149Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Double-sided Tape
scientia non olet · About LEMON Manuals