Removal [08/2019 - ]: Procedure

Refer to REMOVAL [08/2019 - ] 

Refer to PROCEDURE - Step 3

1. Remove the bolt and No. 2 idler pulley sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a screwdriver or equivalent with its tip wrapped in protective tape, hold the water pump pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protective Tape
   *b	Hold
   *c	Turn

2. Remove the 4 bolts and water pump pulley.

   HINT: 

   There is not enough clearance to completely remove the water pump pulley from the water pump shaft. Remove the water pump pulley together with the engine water pump assembly.

1. Remove the 15 bolts, engine water pump assembly, water pump pulley and water pump gasket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002