LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> NX 300 Base, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery / Charging System - Service Information >> Generator >> Installation [05/2019 - ] >> Procedure

Installation [05/2019 - ]: Procedure

  1. INSTALL GENERATOR ASSEMBLY 
    1. Install the 2 wire harness clamp brackets with the 2 bolts.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    2. Install the generator assembly with the 2 bolts.

      Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

    3. Connect the generator connector to the generator assembly.
    4. Connect the wire harness to terminal B with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    5. Install the terminal cap.
    6. Connect the crank position sensor connector and attach the 2 clamps.
  2. INSTALL FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1 [10/2014 - ]

  3. INSTALL FAN AND GENERATOR V BELT 

    Refer to PROCEDURE - Step 1 [10/2014 - ]

  4. INSPECT REAR ENGINE UNDER COVER RH 

    Refer to PROCEDURE - Step 2 [10/2014 - ]

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL 

    Refer to WORK PROCEDURE [05/2019 - ]

    HINT: 

    When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [05/2019 - ]

scientia non olet · About LEMON Manuals