Installation [10/2014 - ]: Procedure

INSTALL FAN AND GENERATOR V BELT

HINT:

When reusing the fan and generator V belt, check the entire belt for wear and cracks on the ribs and back of the belt. Replace any belts with wear or cracks that have reached the core (at 1 point or more) and belts with missing rubber ribs (at 1 point or more).

Set the fan and generator V belt onto each pulley as shown in the illustration.

NOTE:

Make sure the back of the fan and generator V belt is set to the V-ribbed belt tensioner assembly and engine water pump assembly.

Fig 1: Drive Belt Routing

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout	Description
*1	Crankshaft Pulley
*2	Engine Water Pump Assembly
*3	Generator Assembly
*4	Compressor Assembly with Pulley
*5	Idler Pulley Sub-assembly

Using a tool, turn the pulley set bolt of the V-ribbed belt tensioner assembly counterclockwise, and then remove the 5 mm hexagon wrench.

Check that the fan and generator V belt is set correctly to each pulley.

Start the engine and check that the fan and generator V belt rotates smoothly and quietly.

INSTALL REAR ENGINE UNDER COVER RH
1. Install the rear engine under cover RH with the 4 clips.