LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> NX 300 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System / Washer System - Service Information >> Rain Sensor >> Removal [10/2014 - 09/2017] >> Procedure

Removal [10/2014 - 09/2017]: Procedure

  1. REMOVE NO. 1 LANE RECOGNITION COVER (w/ Lane Departure Alert System) 

    Refer to PROCEDURE - Step 1 [10/2014 - 09/2017]

  2. REMOVE RAIN SENSOR COVER (w/o Lane Departure Alert System) 
    1. Detach the 2 claws and remove the rain sensor cover.
      GTY514648Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE RAIN SENSOR 
    1. Disconnect the connector.
      GTY521271Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Release the stopper by pulling it down.
      GTY506766Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Stopper
    3. Remove the rain sensor as shown in the illustration.
  4. CLEAN WINDSHIELD GLASS 

    HINT: 

    • The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated with foreign matter.
    • Check that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue before installing the rain sensor.
    • If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.
scientia non olet · About LEMON Manuals